LT3477
APPLICATIONS INFORMATION
some tweaking of the compensation values (R C and C C
on the V C pin) may be required to ensure a clean inductor
ripple current while the constant-current loop is in effect.
For these applications, the constant-current loop response
can usually be improved by reducing the R C value or by
adding a capacitor (with a value of approximately C C /10)
in parallel with the R C and C C compensation network.
Frequency Compensation
The LT3477 has an external compensation pin (V C ), which
allows the loop response to be optimized for each applica-
tion. An external resistor and capacitor (or sometimes just
a capacitor) are placed at the V C pin to provide a pole and
a zero (or just a pole) to ensure proper loop compensation.
Several other poles and zeroes are present in the closed-
loop transfer function of a switching regulator, so the V C
pin pole and zero are positioned to provide the best loop
response. A thorough analysis of the switching regulator
control loop is not within the scope of this data sheet, and
will not be presented here, but values of 1k and 4.7nF will
Soft-Start
For many applications, it is necessary to minimize the
inrush current at start-up. The built-in soft-start circuit
signi?cantly reduces the start-up current spike and out-
put voltage overshoot. A typical value for the soft-start
capacitor is 10nF.
Switching Frequency
The switching frequency of the LT3477 is set by an ex-
ternal resistor attached to the R T pin. Do not leave this
pin open. A resistor must always be connected for proper
operation. See Table 4 and Figure 4 for resistor values and
corresponding frequencies.
Increasing switching frequency reduces output voltage
ripple but also reduces ef ?ciency. The user should set
the frequency for the maximum tolerable output voltage
ripple.
Table 4. Switching Frequency
be a good choice for many designs. For those wishing
to optimize the compensation, use the 1k and 4.7nF as a
starting point.
Board Layout
As with all switching regulators, careful attention must
be paid to the PCB board layout and component place-
ment. To maximize ef ?ciency, switch rise and fall times
are made as short as possible. To prevent radiation and
high frequency resonance problems, proper layout of the
high frequency switching path is essential. Minimize the
length and area of all traces connected to the SW pin and
always use a ground plane under the switching regulator
to minimize interplane coupling. The signal path including
the switch, output diode D1 and output capacitor C OUT ,
contains nanosecond rise and fall times and should be
kept as short as possible.
SWITCHING FREQUENCY (MHz)
3.5
3
2.5
2
1.5
1
0.5
0.2
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0
R T (k Ω)
2.43
3.65
4.87
6.81
10.2
17.4
43.2
107
0.1
10
R T (kΩ)
100
3477 F04
Figure 4. Switch Frequency
3477fc
10
相关PDF资料
LT3478IFE#PBF IC LED DRVR HP CONS CURR 16TSSOP
LT3486EFE#PBF IC LED DRVR WHITE BCKLGT 16TSSOP
LT3491EDC#TRMPBF IC LED DRIVER WHITE BCKLGT 6-DFN
LT3492IFE#TRPBF IC LED DVR HP CONST CURR 28TSSOP
LT3496IUFD#PBF IC LED DRVR WHT/RGB BCKLT 28-QFN
LT3497EDDB#TRMPBF IC LED DRIVR WHITE BCKLGT 10-DFN
LT3498EDDB#TRPBF IC LED DRVR WT/OLED BCKLGT 12DFN
LT3517HUF#PBF IC LED DRIVER AUTOMOTIVE 16-QFN
相关代理商/技术参数
LT3477EFE#TR 制造商:Linear Technology 功能描述:LED DRVR 4Segment 3.3V/5V/9V/12V/15V/18V/24V 20-Pin TSSOP EP T/R
LT3477EFE#TRPBF 功能描述:IC LED DRVR HP CONS CURR 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3477EFEPBF 制造商:Linear Technology 功能描述:LED Driver 4-Seg 3.3/5/9/../24V TSSOP20
LT3477EUF 制造商:Linear Technology 功能描述:LED DRVR 4Segment 3.3V/5V/9V/12V/15V/18V/24V 20-Pin QFN EP
LT3477EUF#PBF 功能描述:IC LED DRVR HP CONST CURR 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:60 系列:- 恒定电流:- 恒定电压:- 拓扑:线性(LDO),PWM,升压(升压) 输出数:8 内部驱动器:是 类型 - 主要:背光 类型 - 次要:RGB,白色 LED 频率:500kHz ~ 1.5MHz 电源电压:4.75 V ~ 26 V 输出电压:45V 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* 工作温度:-40°C ~ 85°C
LT3477EUF#PBF 制造商:Linear Technology 功能描述:IC, LED DRVR, QFN20
LT3477EUF#TRPBF 功能描述:IC LED DRVR HP CONST CURR 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3477IFE 制造商:LINER 制造商全称:Linear Technology 功能描述:3A, DC/DC Converter with Dual Rail-to-Rail Current Sense